Waveshare LED-Display 2.13 250×122 ePaper Display HAT für Raspberry Pi

Produktbeschreibung

Übersicht

This is an E-Ink display HAT for Raspberry Pi, 2.13inch, 250x122 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.

Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.


Eigenschaften

• No backlight, keeps displaying last content for a long time even when power down
• Ultra low power consumption, basically power is only required for refreshing
• Compatible with Raspberry Pi 2B/3B/Zero/Zero W
• Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
• Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Spezifikationen

• Operating voltage: 3.3V
• Interface: SPI
• Outline dimension: 65mm × 30.2mm
• Display size: 23.71mm × 48.55mm
• Dot pitch: 0.194 × 0.194
• Resolution: 250 × 122
• Display color: black, white
• Grey level: 2
• Partial refresh time: 0.3s
• Full refresh time: 2s
• Refresh power: 26.4mV(typ.)
• Standby power: &lt,0.17mV
• Viewing angle: &gt,170°
  

Interface

SYMBOLDESCRIPTIONVCC3.3VGNDGroundNCNCDINSPI MOSI pinCLKSPI SCK pinCSSPI chip selection, low activeDCData/Command selection (high for data, low for command)RSTExternal reset, low activeBUSYBusy status output, low active

Lieferumfang

• 2.13inch e-Paper HAT
• RPi screws pack (2pcs)
• 9-pin 2.54 pitch SMD pinheader

Dokumentation / Downloads

• http://www.waveshare.com/wiki/2.13inch_e-Paper_HAT