Geekstory BE-220 GPS Module with Flash Navigation TTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

Produktbeschreibung

This BN-220 GPS Module using the latest 10th generation chip When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to gnd, green to txd, white to rxd. The TX LED flash means gps module output normally. The PPS LED flash means gps module locate your place. Data Level : TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable. This BN-220 GPS Module has 4M Flash to save configuration, so you do not need to reset data next time when you use it. Baud Rate : 4800bps to 921600bps, Default 38400bps. What you will get: 1*BN-180 GPS Module; 1*1.00mm 4pins Cable; 1* 20cm 1.0mm 4P Connector Male Cable